Lighting Range Pilots

The surface burners have standing pilots that must be lit initially. To light them:

Light Top Pilots (Standing Pilot Models Only)

1. Be sure the surface burner control knobs are in the "OFF" position.

2. Remove the grates and cooktop.

3. Locate the pilot ports and light each of them with a match. Replace the cooktop and grates.

NOTE: PILOT SHOULD BE 3/8" HIGH. IF THE PILOT IS TOO HIGH OR LOW, YOU CAN ADJUST IN THE FOLLOWING MANNER:

1. Locate the pilot adjustment screw. It can be found by following the pilot line back from the pilot to the oven control.

2. To adjust, use a blade-type screwdriver. Turn the pilot adjustment screw until the pilot is 3/8" high. Do not reduce the flame to less than 3/8" or pilot outage may occur. A larger than recommended pilot flame may generate soot (carbon black) on the bottom of your cooktop.

Light Top Pilots (Standing Pilot Models Only)

Light the oven burner pilot in the following manner.

1. Be sure the oven control knob is in the "OFF" position.

2. Remove the broiler carriage.

3. Hold a lighted match at the top forward section of the pilot (See diagram). No adjustment is required.

4. Replace the broiler carriage.